Aironet PC3500 Betriebsanweisung PDF herunterladen (Seite 63)

1. From the link test command menu, enter the following

parameters:

• IP address of Aironet Access Point:

This parameter specifies the IP address of the Access

Point with which you want to test the RF link. Set

this value before running the link test.

• Number of Packets:

This parameter specifies the number of packets the

link test will attempt to send. The display will show

the number of packets of the specified size that are

successfully transmitted and received. This

parameter is ignored if Continuous Link Test is

selected.

• Packet Size:

This parameter specifies the size of the data packet to

be sent to the Aironet Access Point. Be aware that

the TCP/IP stack that comes with Windows 95 will

fragment packets greater than 512 bytes. Therefore,

the number of packets transmitted will not match the

number of packets received (even if none are lost) if

the packet size is greater than 512 bytes.

• Continuous Link Test:

Selecting this item causes the link test to run

continuously until Stop, OK, or Cancel is selected.

The Number of Packets parameter is ignored if

Continuous Link Test is selected.

2. Once the parameters have been entered, click on the

Start button at the bottom of the dialog box to start the

link test. When the link test is running, necessary

statistics will be displayed and updated periodically.

3. To stop the link test, click on Stop, OK, or Cancel at the

bottom of the dialog box. Once the link test has sent the

number of packets specified, the Stop button will toggle

back to a Start button.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 84 85

Keine Kommentare

Aironet PC3500 Betriebsanweisung Seite 63